MKS DLC V2 + DRIVERS DM542

I think I'll buy this one to play and see : )

Of course this works....the driver does not care from which controller the signal comes only it must come!

I have at the TB 6600 also 23er Nema controlled via the DLC.

But you have to set 800 steps and it does not matter where the jumpers on the DLC under the driver socket are plugged....or pull off all or leave all three on!

It is useless to change the jumpers because only GRBL says in which step resolution and there are 800 steps in GRBL.

Thema

MKS DLC - Stepper Resolution

Moin,

nach dem mich diverse User angeschrieben haben bezüglich der Schrittauflösung und Einstellung in GRBL
Mein Versuch etwas Licht ins Dunkel zu bringen : )
Das folgende Bild bitte gut betrachten!

Ich habe mal folgendes Schaltbild / Möglichkeiten (keine Gewähr ob es richtig ist)


Verbaut (gesteckt) jetzt ein Pololu 8825 (1/32 Microsteps)
Im Bild links der gesteckte Treiber und mittig die Jumper um zu gucken bzw. zu zeigen.
Also sind auch links die Jumper gesetzt nur nicht sichtbar weil der Treiber…

Plottmania

29. August 2021

What Voltage did you provide for the DM542?

12 V is not sufficient. Can you show your current wiring again?

This is how it would look and work for me....I bet :

If the colors are wrong, I apologize.

So that the stepper really run well should be a voltage of at least 36 volts!

Hallo Taz,

Replace cable at the connector and all is well.

Look at the exposure...

https://plottmania.de/media/11…-out-jpg/?thumbnail=large

Why not?

Al long as it can handle the current load used by the motors that's totally fine.