MikeP Anfänger

  • 60
  • Mitglied seit 22. April 2024
  • Letzte Aktivität:
Beiträge
8
Erhaltene Reaktionen
1
Punkte
46
Profil-Aufrufe
131
  • MikeP

    Beitrag
    I managed to get the MKS DLC32 v2.1 working the same as when I was using Arduino.

    When using external drivers - Do not connect the ENA pin to the motor drivers. The Stepperonline drivers I am using they have mentioned in their technical sheet by default…
  • MikeP

    Beitrag
    […]

    $5 is set to 1 for Normall Connected. I have used UGS and the MKS controller is reporting the detection of the 3 switches correctly when I press them manually. If I reconnect the Arduino it works perfectly but with this MKS DLC32 v2.1 it seems to…
  • MikeP

    Beitrag
    […]

    I have a strong feeling the homing issue I am experiencing is due to the fact my limit switches are wired in a 2 wire NC configuration. The MKS is not detecting any presence of limit switches being connected. So it is moving 4mm and stopping and…
  • MikeP

    Beitrag
    […]

    Good point! In the console the MKS DLC32 v2.1 controller is reporting v1.1 but not sure if is most current v1.1h - the firmware is V2.1.0_H24_20220511_01_N_CNC and I haven't been able to figure out a way to updating just the Gbrl.

    I will investigate…
  • MikeP

    Beitrag
    […]

    Thank you for your reply. I have checked the wiring is correct and the GND pins from the driver terminals all ground to the controller.

    In my Arduino setup I had ENA+ connected although in the DM542T (v.4.0) manual it states default is no-connection.…
  • MikeP

    Beitrag
    When I built my cnc i started with a Arduino controller and it worked flawlessley when connected to DM542T external controller. Homing cycle everything worked perfectly. So I thought now it is time to find a good priced offline controller and decided to…
  • MikeP

    Beitrag
    Danke für Ihre Antwort. Ich komme aus England und benutze einen Übersetzer, um zu antworten.
    DM542T-Treiber eingestellt auf 10 Mikroschritte (200 * 10)/5 mm (Kugelumlaufspindelsteigung) = 400
    100 $ = 400.000 (Wegauflösung der X-Achse, Schritt/mm)
  • MikeP

    Thema
    Ich bin gerade diesem Forum beigetreten, nachdem ich eine Nachricht auf dem YT-Kanal von Plottmania gepostet habe. Ich bin ein CNC-Enthusiast und bin auf Ihren Kanal gestoßen, als ich nach einem Video zur Verbindung des MKS DLC32 v2.1 mit externen…