MKS DLC V2 + DRIVERS DM542

Hallo Tazmahv,

why should this not be possible?

I can install any driver to any DLC and I have also shown: TB 6600 and there is no difference from the connection to the DM542

I use but adapters from Barton Dring wen the cloned Y-axes

MKS DLC 2.0 - Plottmania.de

Regards

If you want to connect the dm542 to the board you can either use Adapter boards from Barton Dring that route the control signals to the Motor ports, like Stephan did.

Or you connect the DM542 directly to the control pins on the board.

In both cases the currently mounted driver module must be removed.

Christian, the adapter is very special and not a driver.

The signals for the TB6600 come out of the adapter.

Is therefore only an adapter that loops something because I do not like the pins : )

On the left on the X-axis the MKS adapter and on the Z-axis the adapter from Barton.

Pay attention to the colors of the cables in my videos!!!

The adapter from Barton is for the Y-axis so that I can connect two drivers to the blue connectors of the controller.

You really connected everything correctly?

I know Stephan. thats what i said.

tazmahv

I don't have a MKS Board at hand, but if you connected the right pins ist should work.

What you should check is the Enable Singal.

If enable is high, the DM452 switches OFF!

So, high means Driver disabled and low or not connected means Driver enabled.

Are you sure the 4-pin headers carry the right signals? The silkscreen was not readable on your pictures.

If i see your wiring picture correctly, you got the Polarity of all Signals wrong.

The Pul-,Dir- and Ena- Terminals should be connectrd to GND and the Signal pins from the MKS to the respective Pul+, Dir+ and Ena+ Terminals, as all control singnals are active high on the DM542

No.

Step goes to Pul+

Dir goes to Dir+

and enable goes to ENA+

The Minus pins are all connected to GND on the 4-pn header.

Yes, that looks correct.

Hope you didn't fry something from your earlier tries.

You're Welcome.

Have a nice Evening.

tazmahv

Would you please be so kind and provide us with yout first name and nationality?

Did you make any progress already?